The Fiesta Owners Association

Specification and Class Rule Page
The Specification
Length overall                       640mm                                    25.1/4"

Height overall                       1250mm                                  49.1/4"

Beam                                    160mm                                     6.3/8"

Weight overall                      1.5kg                                        3lb.6oz

Mast height                           940mm      37.0"

Sail area                               2228 sq.cm                             345 sq"

Design draught                    257mm                                    10.1/8"
The Class Rules

Hull
Shall only be as supplied by the manufacturer.

Deck
As supplied by the manufacturer or own flat sheet deck which can be customised with planking or plastic covering.

Servos
For sail and rudder control any servo can be used. Sail control servo shall have an extended arm fitted. Drum winches are not permitted.

Fin and rudder
Only as supplied by the manufacturer, both may be re-shaped to an aerofoil section if desired.
Fin depth measured from lowest point of hull to bottom of lead bulb 220mm maximum.

Lead bulb
As supplied by the manufacturer.

Rigging, sheeting and deck eyes
As supplied by the manufacturer or own preference.

Kicking strap
As supplied by any manufacturer or to own make.

Booms
Jib boom as supplied in kit maximum length 255mm , any counter balance weight to be within this lenght, the boom shall not project beyond the bow.
Main boom as supplied in the kit maximum length 250mm.

Mast
As supplied by the manufacturer.

Sails
As supplied by the manufacturer. Sails to carry boat number on jib and or mainsail, uppermost number to be on starboard side, from 2006 these must be minimum 50mm in height and black. The F  logo at top of mainsail pre-determined placement by template supplied in kit.

Note
If you are in any doubt about the legality of your yacht, you should contact the Owners Association, for contacts click here